Instruction Manual

Edit-Mode
The edit-mode allows adjusting di!erent settings for the individual synthe-
sizer channels as well as global settings for the PerFourMer MKII. For easy
handling, a list of all available parameters is printed to the unit's top-sur-
face above the SELECT/SEQ control.
To change a parameter, perform the following steps:
1. Press the EDIT-button to enter edit-mode.
2. Use the SELECT/SEQ control to select the desired parameter (1..10).
3. Enable or disable the selected parameter using the synthesizer
channel's TRIG-buttons. Parameters 1 to 8 are set individually per syn-
thesizer channel while parameters 9 and 10 are global settings globally
valid for the PerFourMer MKII.
4. Exit edit-mode by pressing the Edit-button.
The edit-mode allows adjustment of the following parameters:
1 - PITCH BENDER (VCO)
This parameter enables/disables pitch modulation using the pitch
bender.
2 - MODULATION WHEEL (PWM)
This parameter enables/disables modulation of the oscillator's square
waveform's pulse width through the modulation wheel.
3 - AFTER TOUCH (VCF)
This parameter enables/disables modulation of the filter's cuto! fre-
quency through (channel) after touch data.
4 - VELOCITY (VCA EG)
This parameter enables/disables modulation of the VCA's envelope
amount through incoming velocity data.
5 - AUTO GLIDE
This parameter enables/disables the auto-glide function. With audio-
glide enabled, a glide (portamento) will only be performed with two
adjacent notes being played overlapping.
Owner's Manual VERMONA PERfourMER MKII
- 29 -