Manual

Installation
The TAI-4 is compatible to eurorack modular systems and has to be connected to
the A-100 system bus for operation.
Follow the safety instructions and warnings stated in your A-100s
manual when installing the module.
Before installing the module be sure to disconnect the modular
system from mains!
•
Connect the 10-pin connector on the TAI-4s rear to the ribbon cable that comes
with the TAI-4. The color marked stripe on the cable is oriented to the bottom.
(see illustration 1)
•
Connect the other end of the ribbon cable to the 16-pin connector on the
eurorack style power distribution board of your modular system. The colored
stripe has to be oriented to the negative 12 volt supply line (bottom).
•
Use the screws that came with your TAI-4 to mount the module into the modular
frame.
•
Now connect the modular system to the mains and switch it on.
Illustration 1: Connecting the TAI-4 to the system bus
TAI-4
ribbon cable
system bus
Owner's Manual VERMONA TAI-4 - transformer-isolated audio interface
- 2 -