User Manual

Getting Started
To ensure top quality we carefully checked the VSR-3 before packaging.
Nevertheless, the unit could have been damaged during transportation.
Therefore, we ask you to take a serious look at the unit when unpacking it.
Do not hesitate to contact us, should there be anything unusual on the
VSR-3 itself or its packaging.
You should find the following items in the box:
•
the VSR-3 itself
•
a power cord
•
this manual
Connections and Powering
If you came here without any problems, you can finally start up your new
VSR-3.
ATTENTION!
Before connecting the VSR-3 all level controls (GAIN and
OUTPUT LEVEL) as well as the level controls of the following
equipment must be set to zero. On the VSR-3 that means
the far left knob position.
Switch o! the VSR-3 before connecting.
1. Connect the provided power cord to the MAINS IN (10) jack.
2. Connect on of the input jacks (1) or (7) of the VSR-3 to the audio
output of your signal source, i.e. an instrument (guitar, synthesizer), a
CD player, the output of your DAW, etc.
3. Connect one (or both) OUTPUT jacks (8) to an appropriate audio input
of your amplifier, mixing console, audio interface, etc.
4. Start the VSR-3 by switching on the POWER switch (11) on the rear.
The LED above the BYPASS SWITCH (6) will be lit.
5. The VSR-3 is operational.
Owner's Manual VERMONA VSR-3 - vintage spring reverb
- 4 -