User Guide

CAUTION:

The halogen bulb is very delicate and should

not be handled with bare hands. After

removing it from the box, grasp it gently by

the plastic covering or a soft cloth.

Step 5d. Remove the ceramic wire nuts from the

wires and set aside for use in the next two steps.



WHITE wire coming from the bottom of the motor.

Secure with a ceramic wire nut.



BLACK wire with white stripe coming from the

bottom of the motor. Secure with a ceramic wire

nut.

Step 5e. Carefully tuck in the wires so they do not get

pinched. Align the three holes on the socket plate with

the screw holes on the switch housing. Insert three

socket plate screws (Pack E) and tighten until secure

using the screwdriver as shown in Figure #1.

Ceramic

Wire Nuts

Socket Plate

Screws

Halogen

Lightbulb

Shield

Lightbulb

Sockets

Halogen

Lightbulb

GLASS INSTALLATION

Figure #1

Figure #2

Figure #3

Install Halogen Bulb

Step 6a. Insert one end of the halogen bulb into the

socket. Push the end of the socket, then insert the

other side of the halogen bulb into the socket. as

shown in Figure #2.

Step 6b. Install the glass shield by pushing it into

place with the clips on the light socket as shown in

Figure #3.

NOTE: In compliance with US Federal Energy

Regulations, this ceiling fan contains a device that



Exceeding that limit or the marked limit on this product

