- Vermont Castings Natural Vent Gas HeaterHome owner's Installation and Operating Manual SNV30: 3980-3996

23
Stardance Natural Vent Gas Heater
20007067
Stardance Natural Vent Gas Heater (SNV30) (continued)
Models 3980-3996
4. Lava Rock - Burner 57897
5. Gasket, Glass Med. Knit - RDV40 1203702
6. Glass, DV25 1601691
7. Glass Frame Assembly SDV30 30000127
8a. Valve RN Honeywell VS8420E 2038 (Serial #’s up to 6361)* 10001782
8b. Valve RP Honeywell VS8420E 2020 (Serial #’s up to 6361)** 10001759
9a. Pilot Assembly 3Way N/DV RN 0.199.706 10002264
9b. Pilot Assembly 3Way RP 0.199.703 10002265
10. Thermopile 51827
7533113
11a. Thermocouple 24” 53373
7531137
12. Electrode Ignitor w/ cable SIT 24 10001297
13. Nut Electrode SIT #0.974.144 57886
14. Tubing Pilot w/Fitting SIT 10001296
15. Pilot Top Convertible 10002266
16a. Orifice Pilot #62 NG Top Convertible 10002268
16b. Orifice Pilot #35 - LP Top Convertible 10002269
17a. Burner Housing Assembly 20005264
18. Grate Burner JDV 20002167
19. Wire w/Straight Term 2 End 50” 10002582
20. Switch Rocker 30000874
21. Door, Control - FS/HM 1301087
22a. Orifice Hood #69 - 0.0292” (Front LP) 30000513
22b. Orifice Hood #54 (Front Natural) 20000130
22c. Orifice Hood #54 (Rear LP) 20000130
22d. Orifice Hood #44 .086” (Rear Natural) 30000334
23. Bracket - Right Log 20005259
24. Bracket - Left Log 20005258
25. Handle Pkg, Ceramic w/Screw 0004345
26. Top, Stardance NV Refer to Enamel Parts Chart Page 24
27. Gasket Burner Pan 20002282
28. Gasket Base Pan Inner 20002566
29. Spill Switch Wire Assembly 300001080
30. Front, S30ODK Refer to Enamel Parts Chart Page 24
31. Door, Right Stardance Refer to Enamel Parts Chart Page 24
32. Door, Left Stardance Refer to Enamel Parts Chart Page 24
33. Front Pawl Assembly, Ash Door - ENC 5004025
34. Front Steel Handle/Shaft - NI/VER 30002717
35. Nut, Hex Jam 3/8 - 16 TopLK-Z 1203290
36. Interrupter Block 30000069
37. Grille, SNV30/KFDV 30000159
38. Draft Hood/Flue Collector Assembly 20005227
39. Left End Refer to Enamel Parts Chart Page 24
Ref. Description SNV30
NOTE: Silicone adhesive, purchased from a local hardware store, can be used to attach the pad.
*When converting to SIT valve, must order RP275
**When converting to SIT valve, must order RP269