Operating instructions

10002789/0 -21- DBT33/DBT36/DBT39
INSTALLATION OF LOGS
& LAVA ROCK
Refer to the log identication chart to identify specic log
numbers.
1. Remove the front glass / frame assembly.
2. Remove the logs from their packaging.
The logs are fragile and should be handled
with care.
Keep the packaging material out of the reach of
children and dispose of the material in a safe
manner
3. Place the rear log (see chart for identication number)
in the rear support channel. The at face should be at
against the rear of the rebox and the log should be central
in the channel.
4 Align the holes in the base of the left front log with the
studs on the left support bracket located over the burner
housing and place the log in position.
5. Align the holes in the base of the right front log with the
studs on the right support bracket located over the burner
housing and place the log in position.
6. Place the left top log in position by aligning the hole on
the underside of the log with the lug on the top face of
the rear log. The front end of the log rests in the cut-out
on the left front log.
7. Place the right top log in position by aligning the hole on
the underside of the log with the lug on the top face of
the rear log. The front end of the log rests in the cut-out
on the right front log.
8. Scatter the ember material over the burner housing in font
of the 2 front logs. Do not pack this material tightly,
separate it when unpacked and keep it in a loose condi-
tion.
9. Scatter the lava rock material around the rebox base.
Do not place any of the lava rock material on
the burner housing.
Log Identication Chart
Location DBT33 DBT36 DBT39
Front left BA2 BB6 BC5
Front right BA3 BB7 BC6
Rear BA4 BB8 BC7
Top left BA5 BB9 BC8
Top right BA6 BB10 BC9
Fig. 41
Fig. 42
Fig. 43
DBT33
DBT36
DBT39