Technical data

21
Verona CR 43
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Note:
If you tune into a station which has already
been stored on another memory bank, the
corresponding preset button and the memo-
ry bank will start flashing on the display : for
approx. five seconds.
Automatically Storing the Stron-
gest Stations (Travelstore)
With Travelstore, you have the opportunity to
automatically store the six most powerful FM
stations of your local reception area and have
them sorted according to their frequencies.
This feature is of special use while travelling.
• Press the FM•T button ? for at least
two seconds.
The set searches for the next FM stati-
ons and sorts them on the “T” (Travel-
store) storage level. Once the process
is finished, the car radio tunes in to the
first station.
If required, it is also possible to manually
store a station on the Travelstore level. If less
than five stations can be received, the free
buttons are represented by dashes for a
short period of time.
Activating a Stored Station
If required, the memorized stations can be
activated at a keystroke.
• Select the desired waveband by press-
ing the FM•T button ? or M•L rocker
switch > and the corresponding FM
memory bank.
For this, press the FM•T button ? until
the display : shows I, II or III, or T.
• Briefly press the required preset button
<.
Briefly Sampling a Station
(Radio Scan)
Starting with the currently tuned in station,
you can have the following ones briefly sam-
pled for approx. eight seconds each.
• Press the knob 1 for approx. 1 sec.
If the following station is found, it is
reproduced for approximately eight
seconds.The station’s frequency starts
blinking on display :; if it has already
been memorized, the corresponding
preset button and the storage level indi-
cator starts blinking on display :. Sub-
sequently, the set starts searching for
the next station.
For selecting a sampled station:
• Press the knob 1 once again.
The Scan function is off.
After the search operation has been conclu-
ded, and no station has been chosen, the
radio starts playing the station from which
Station Scan was started before.
Sampling Memorized Stations
All memorized stations of a waveband can be
briefly sampled.
• Press the PS button @.
One after another, the car radio will
then start introducing all memorized
stations of the selected waveband.
The set either samples the stations of
storage levels I-III or of the Travelstore
level “T”. This depends on the current
switching status.
If a preset button has no station alloca-
ted, this button is skipped.
To terminate this function:
• Press the PS button @ once again.
The station currently sampled is
maintained.