Installation Instructions

INSTALLING THE WALK DOOR
Pre-hung walk doors are typically attached to the frame with screws through the door jamb into the building frame on both
sides. Some doors are flange mounted on the face of the door frame to the building with pan head screws and some
doors are a combination of the two. Place your door in the opening with the front edge of the door flush or touching the
outside of the nailer tubes and attach the door to the frame according to door manufactures instructions. If you want to
use screws provides by the door manufacturer you will have to drill pilot holes in the frame for the screws. If the door is
flange mounted use #10 x 7/8” pan head self-drilling screws to attach the flange to the nailer tubes.
DOORS THAT ARE NOT FLANGE MOUNTED WILL
BE MOUNTED THROUGH THE SIDE JAMBS TO
THE FRAME SOME TIMES USING ONE OF THE
HINGE HOLES.
NON-FLANGE
MOUNTED DOOR
FLANGE MOUNTED
DOOR
USE PAN SCREWS THROUGH THE
FLANGE INTO THE VERTICAL NAILER
TUBES TO ATTACH A FLANGE MOUNTED
DOOR.
PAGE 16