Installation Instructions

PAGE 35
STEP 16: INSTALLING CORNER TRIM
Cut corner trim to fit the corner height of your building. Corner trim should sit down in sheeting ledge if your slab has one.
Install a piece of Corner Trim on the 4 corners of the building with 1” Painted, Self-Drilling Screws. Install the screws
through the flat flanges at the edges of the trim into the wall girts (front or back) hat Channel (sides).
FRONT OR
BACK OF
BUILDING
SIDE OF BUILDING
#12 X1” PAINTED,
SELF-DRILLING SCREW
WITH RUBBER WASHER
CORNER TRIM
STEP 17: INSTALLING EAVE TRIM
Install Outside Foam Closure Strips along the outside, top edge, of every
side panel before you install Eave Trim. Set a piece of trim in place to deter-
mine the location of the closure. Trim the Closures as needed at the corners
of the building. ( See illustrations below)
Attach the Eave Trim at the top of the side sheet metal all the way down
both sides of the building with #12 x 3/4” Painted, Stitching Screws with
Rubber washers. Place the screws into the center of every other major rib.
To position the Eave Trim place a straight board or long level on top of the
roof purlins and extend it out to act as a stop for the top of the Eave Trim.
See the illustration below. Eave Trim comes in 12’-3” lengths. You will need
to overlap the trim about 3” at the ends. Trim excess at end of building flush
with the outside of the corner trim.
Eave Trim should overlap Corner Trim. Your trim will look better if you start
at the back of the building and work forward.
STRAIGHT PIECE OF WOOD
OR LONG LEVEL
SIDE SHEET METAL
PANEL
EAVE TRIM
OUTSIDE
FOAM
CLOSURE
STRIP
TRIM AT CORNER
SIDEWALL
PANEL
CORNER TRIM
1 1/2” SQUARE GIRT
HAT CHANNEL
Height of panel
with sheeting ledge
Height of panel
no sheeting ledge
ROOF PURLIN
EAVE TRIM
STITCHING SCREW