Installation Instructions

INSTALLING GABLE TRIM GABLE TRIM WILL COME IN 13’ LENGTHS.
Gable Trim will finish the joints at the gable ends of the building between the roof and the end wall panels.
Clip one piece of gable trim in the front center and the top back flange as shown. Fold the trim so the front flanges over-
lap. This will go at the peak of the building. Cut one of the remaining pieces in half to create extensions which will
Under lap the peak trim at both ends. If your building is 30’ wide you will insert a full 13’ piece at both ends. The lower
ends of the gable trim extensions should be set flush with the lower edge of the roof panels. The rest can lap under the
peak piece.
Fasten the Gable trim to the Roof with (3/4 painted Self-Drilling screws with rubber washers) through the flange and into
each roof purlin. Fasten the trim to the Gable End Panels with 3/4” painted, Stitching screws into the top of each major rib
on the front face.
Keep the front of the trim flush with the front of the building and the top
flush with the roof.
GABLE TRIM
ROOF PANEL
OVERLAP
3/4” STITCHING
SCREWS EVERY
MAJOR RIB
PAGE 38
OVERLAP
CUT FRONT
CENTER OF
TRIM
CLIP FLANGE
PLACE 1 SCREW IN
CENTER OF OVERLAP
FOLD AT
PEAK
TRIM EXTENSION
REPEAT THIS ASSEMBLY ON
GABLE AT OTHER END OF
BUILDING
3/4” PAINTED, SELF-DRILLING
SCREW, WITH RUBBER WASHER
3/4” SELF-DRILLING
INTO ROOF PURLINS
ROOF PURLIN
5 1/8”
5 1/8”
CORNER/GABLE TRIM