Instructions / Assembly

ManualsBrandsVersaTube ManualsKitchen12 ft. x 20 ft. x 8 ft. Garage

NOTE: You can join the ends of the insu-

lation by making square cuts on both

pieces to be joined and taping the seam

with seam tape found in your kit. Use

seam tape to clean up loose edges and

any other application where a single

sided tape will do the job.

NOTE: TRIMMING AROUND DOORS

AND WINDOWS

Insulation must be trimmed around

doors and windows. Using your utility

knife, trim the insulation even with the

edge of the J-Trim back flange and

tape it in place with seam tape. You

must leave room for the sheet metal

panels to fit into the J-Trim.

TAPE

J-TRIM

EDGE OF

BACK FLANGE

INSULATION

STEP 3: INSTALLING FRONT AND BACK INSULATION

Measure and cut pieces of insulation slightly longer than you need to run from the

base rail or door header to the roof frame. Install double sided tape on the front of

the roof frame and the base rail or door header and spots in-between. Press the

insulation panels to the frame, trim along the top of the roof frame and install sheet

metal panels as instructed in your building assembly instructions. On 12’ and 20’

wide buildings start with a panel of insulation centered in the end of the building. On

24’ and 30’ wide buildings start with the seam of two insulation panels centered in

the building end. Sheet metal panels are installed from the center to both sides.

TAPE ON

FRONT

TAPE ON BACK

ILLUSTRATIONS SHOW A 20’ WIDE BUILDING

STEP 4: INSTALLING INSULATION ON THE ROOF

Starting on one side of the roof at the same end of the building

that you started the side panels. Install double sided tape on top

of the side insulation as shown. You should notch out a 2” section

of the side insulation seam to get the tape to lay down properly.

Run another strip of double sided tape on the top hat channel or

roof purlin on the other side of the roof. Measure and cut insula-

tion to fit from the side insulation to the top hat channel or purlin

on the other side of the roof. Cut the insulation a little long. You

can trim later if you like. Line up the edge without the adhesive

strip with the center of the end frame tube as you did the side

panels and press the insulation in place. (Remove slack in the

insulation as much as possible.) Install additional panels as you

did the sides of the building. Install Sheet metal panels as you go

according to the building installation instructions.

On the other side of the roof, run double sided tape on the top of

the side insulation and on the top edge of the roof insulation from

the other side of the roof. Measure and cut insulation to extend

slightly over both strips of tape. Line the edge of the insulation

without an adhesive strip up with the center of the end frame tube

as you did the sides and press the insulation in place. Install

sheet metal as you go. Trim off excess insulation at the end of the

building.

DOUBLE

SIDED TAPE

DOUBLE

SIDED TAPE

INSULATION

SIDE INSULATION

PAGE 44