User's Manual

EVX-5300 OpErating Manual
10
advanced operatIon
pa
(
puBlIc address
)
Press (or press and hold) the assigned
PF
key to use the transceiver as a PA ampli-
er. The Public Address can be used even while scanning and receiving a call.
When the Public Address function is activated, the Transceiver Status Indicator
(“
A
”, “
B
” or “
C
”) will illuminate, if the “Public Address” status is assigned to
one of the Transceiver Status Indicator.
eXt acc 1
Activates the output port “1” of the D-Sub 15-pin Accessory Connector while
pressing the assigned
PF
key.
eXt acc 2
Press (or press and hold) the assigned
PF
key to toggle the output port “2” of the
D-Sub 15-pin Accessory Connector “On” and “Off”.
emergency
The
EVX-5300
series includes an “Emergency” feature in either analog or digital
modes, which may be useful for alerting another party monitoring on the same fre-
quency as your transceiver’s channel.
Press the assigned
PF
key to initiate an emergency call on the pre-dened channel.
For further details contact your Vertex Standard dealer.
When the Emergency feature is activated, the Transceiver Status Indicator (“
A
”,
“
B
” or “
C
”) will illuminate, if the “Emergency” status is assigned to one of the
Transceiver Status Indicator.
lone worKer
Press (or press and hold) the assigned
PF
key to toggle the Lone Worker feature
“On” and “Off”.
The Lone Worker feature is designed to emit an alarm for 30 seconds when the
Lone Worker Timer (programmed by your Vertex Standard dealer) has expired. If
the user does not reset the timer by pressing the
PTT
switch, the radio switches to
the Emergency mode.
cH up/down
Press (or press and hold) the assigned
PF
key (generally the [

]/[

] key) to se-
lect a different channel.