User's Manual

EVX-5300/-5400 OpErating Manual
23
call
When using the DTMF Paging System
This feature, if enabled, allows the user to change the 3-digit Page Call code, used
to call other similarly-equipped stations. Press (or press and hold) the assigned
programmable key, followed by the three digits representing the Page Call code of
the station you wish to call. Three tones will be heard after the last key is pressed (the
new code will now be transmitted).
The receiver squelch of the other station will be opened, and you can begin com-
munication.
When using the 2-tone/5-tone Signaling System
This feature, if enabled, press (or press and hold) the assigned
PF
key to send a
2-tone/5-tone sequential tone.
When using the MDC1200 System
This feature, if enabled, press (or press and hold) the assigned
PF
key to send an
MDC1200 code.
r
Press (or press and hold) the assigned
PF
key to enter the “Call Menu” mode.
r
Press the
[

]
/
[

]
keys (or
[
P1
]
/
[
P2
]
keys) to select the desired Call mode,
then press the
[
P4
]
key to accept the selection. (You may cancel the selection
by pressing the
[
P3
]
key).
r
Press the
[

]
/
[

]
(or
[
P1
]
/
[
P2
]
keys) to select the station to be called.
You may enter the station’s ID number (four digits) directly from the micro-
phone’s key (
[
0
] - [
9
]
,
[
A
]
-
[
D
]
,
[
#
]
: substitute for “E”, and
[

]
: wild card), if
the optional
MH-75
A8J
microphone is used.
r
Press the
PTT
switch to send an MDC1200 call.
status sEt
(
This function is only available in the
EVX-5400
)
Press (or press and hold) the assigned
PF
key to change the 5-tone status code.
To change the status code, select the desired digit by pressing the
[
P1
]
key, then
change the number by pressing the
[
P2
]
/
[
P3
]
key, and store the number by press-
ing the
[
P4
]
key.
You may enter the 5-tone status code directory from the microphone’s numeric key
(
[
0
] - [
9
]
), if the optional
MH-75
A8J
microphone is used.
adVancEd opEratIon