Operating Manual

EVX-539 OpErating Manual
10
opEratIon
Preliminary Steps

Install a charged battery pack onto the transceiver,
as described previously.

Screw the supplied antenna
onto the Antenna jack.
It is not recommended to op-
erate this transceiver without
an antenna connected.

If you have a Speaker/Mi-
crophone, we recommend
that it not be connected un-
til you are familiar with the basic operation of the
EVX-539
. Refer to page 11 for more information
about Speaker/Microphone usage.
IMPORTANT NOTE
Water resistance of the transceiver (IP57: 1
meter / 30 minutes) is assured only when the
following conditions:

Battery pack is attached to the transceiver;

Antenna is connected to the antenna jack;

and
MIC/SP
cap is installed in the
MIC/
SP
jack.

Use of a speaker microphone in the acces-
sory connector negates the IP57 rating.
Operation Quick Start

Tu r n the t o p panel’s
VOL/PWR
knob clock-
wise to turn the radio
on.

Turn the top panel’s
CH
Selector knob to choose
the desired operating
channel. A channel name
will appear on the LCD.
The radio announces the
channel number, if the Channel Announcement
Feature is enabled via the clone editor software.

If you want to select the operating channel from a
different Channel Group, press (or press and hold)
the Programmable key (assigned to the “
group
up/doWn
” function) to change desired Channel
Group before selecting the operating channel.
Note: Some models are programmed so that the
operating channels are selected by the Program-
mable key and the Channel Group is selected by
the
CH
Selector knob.
FCC ID: AXI11154620
IC: 10239A-11154620