Operating Manual

EVX-539 OpErating Manual
24
rEsEt
Press (or press and hold) the assigned
PF
key to reset
the RFC (Ready for Communication) condition.
call 1 to call 5
Press, (or press and hold), the assigned
PF
key to
send a pre-dened 2-tone Sequential Tone Group (on
an analog channel) or a pre-dened Digital Contact
List (on a digital channel).
codE up/doWn
Press, (or press and hold), the assigned
PF
key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
codE sEt
You can change the desired digit of the 5-Tone en-
code code using this function:

Press, (or press and hold), the assigned
PF
key.

Enter the desired 5-Tone encode code directly
from the keypad
([
0
]
-
[
9
]
key and
[
Ý
] (
wild
card
)
key
)
.

Press the
[
D
]
key to store the new setting. The
display indicates “- SET -” briey, then reverts to
the normal channel indication.
You may cancel the new setting by pressing
the
[
C
]
key. In this case, the display indicates
“- CANCEL -” briey.
spEEd dIal
Your Vertex Standard dealer may have pre-pro-
grammed Auto-Dial telephone number memories into
your radio.
To dial a number, press, (or press and hold), the as-
signed
PF
key, then press the keypad
([
0
]
-
[
9
]
key
)
corresponding to the Auto-Dial memory number list
provided by your Vertex Standard dealer or Network
Administrator. The DTMF tones sent during the dial-
ing sequence will be heard in the speaker.
dtmF codE sEt

Press, (or press and hold), the assigned
PF
key to
start entering the DTMF dialing sequence.

Enter the DTMF digit directly from the keypad
([
0
]
-
[
9
]
key
)
.

After entering all DTMF digits, press the
PTT
switch to transmit the DTMF code.
advancEd opEratIon
FCC ID: AXI11154620
IC: 10239A-11154620