Operating Manual

4 EVX-261 OPERATING MANUAL
WARNING! IC RSS GENERAL REQUIREMENT
ENGLISH
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
This radio transmitter (identify the device by certification number, or
model number if Category II) has been approved by Industry Canada to
operate with the antenna types listed at the right with the maximum per-
missible gain and required antenna impedance for each antenna type in-
dicated. Antenna types not included in this list, having a gain greater than
the maximum gain indicated for that type, are strictly prohibited for use
with this device.
When transmitting, hold the radio in a vertical position with its microphone 1 inch (2.5 cm) away from your
mouth and keep the antenna at least 1 inch (2.5 cm) away from your head.
The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-Talk con-
¿ gurations.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than 50% of
the time can cause IC RSS General Requirement to be exceeded. The radio is transmitting when the red LED on
the top of the radio is illuminated.
Body Worn Operation: When worn on the body, always place the radio in a Vertex Standard approved clip, hold-
er, holster, case, or body harness for this product. Using approved body-worn accessories is important because
the use of non-Vertex Standard approved accessories may result in exposure levels, which exceed the occupation-
al/controlled environment RF exposure limits.
VHF MODEL UHF MODEL
ATV-8A: í2.15 dBi, 50-ohm ATU-6A: í2.15 dBi, 50-ohm
ATV-8B: í2.15 dBi, 50-ohm ATU-6B: í2.15 dBi, 50-ohm
ATV-8C: í2.15 dBi, 50-ohm ATU-6C: í2.15 dBi, 50-ohm
ATV-6XL: í2.15 dBi, 50-ohm ATU-6D: í2.15 dBi, 50-ohm
ATU-6F: í2.15 dBi, 50-ohm
ATU-6DS: í2.15 dBi, 50-ohm
Exhibit 8: Operating Manual FCC ID: AXI11374620
IC: 10239A-11374620
Vertex Standard LMR, Inc.