Operation Manual

EVX-530 SEriES OpErating Manual
32
speed dIal
Your Vertex Standard dealer may have pre-pro-
grammed Auto-Dial telephone number memories into
your radio.
To dial a number:
In the
EVX-531/-534
, press, (or press and hold), the
assigned
PF
key, then press the
SIDE-1
/
SIDE-2
but-
tons (or
[
A
]
/
[
B
]
keys) to select the Auto-Dial memory
number you wish to dial. Press the
PTT
switch to
send a pre-defined DTMF tone. The DTMF tones
sent during the dialing sequence will be heard in the
speaker.
In the
EVX-539
, press, (or press and hold), the as-
signed
PF
key, then press the keypad
([
0
]
-
[
9
]
key
)
corresponding to the Auto-Dial memory number you
wish to dial. The
EVX-539
send a pre-dened DTMF
tone, and the DTMF tones sent during the dialing se-
quence will be heard in the speaker.
dtmf code set
(
eVx-539
)
r
Press, (or press and hold), the assigned
PF
key to
start entering the DTMF dialing sequence.
r
Enter the DTMF digit directly from the keypad
([
0
]
-
[
9
]
key
)
.
r
After entering all DTMF digits, press the
PTT
switch to transmit the DTMF code.
call
(
eVx-531
)
Press, (or press and hold), the assigned
PF
key to
send a 2-tone/5-tone sequential tone.
call
(
eVx-534 & eVx-539
)
The Call feature of the
EVX-534/-539
is different by
the operating system and operating mode.
When using the DTMF Paging System
(
eVx-539
)
This feature, if enabled, allows the user to send any
3-digit Page Call code, used to call other similarly-
equipped stations. Press, (or press and hold), the as-
signed
PF
key, followed by the three digits represent-
ing the Page Call code of the station you wish to call.
Three tones will be heard after the last key is pressed
(the new code will now be transmitted).
The receiver squelch of the other station will be
opened, and you can begin communication.
When using the 2-tone/5-tone Signaling System
This feature, if enabled, Press, (or press and hold), the
assigned
PF
key to send a 2-tone/5-tone sequential
tone.
adVanced operatIon