Operation Manual

EVX-530 SEriES OpErating Manual
37
status set
(
eVx-534 & eVx-539
)
You can change the 5-tone status code using this
function:
r
Press, (or press and hold), the assigned
PF
key to
change the 5-tone status code.
r
Enter the 5-tone status code directly from the
keypad
([
0
]
-
[
9
]
key
)
.
r
Press the
[
D
]
key, The display indicates “- SET -”
briefly and store the new number to the 5-tone
status code.
You may cancel the new setting by pressing
the
[
C
]
key. In this case, the display indicates
“- CANCEL -” briey.
status up/doWn
(
eVx-534 & eVx-539
)
Press, (or press and hold), the assigned
PF
key to
select a 5-tone status code from the pre-dened status
list.
status checK
(
eVx-534 & eVx-539
)
Press, (or press and hold), the assigned
PF
key to
check the 5-tone receive status code. When you press
this key, the display will indicate the “Message” cor-
responding to the receive status condition per the pre-
dened status list.
adVanced operatIon
duty
(
eVx-534 & eVx-539
)
Press, (or press and hold), the assigned
PF
key to
toggle the Duty function of the 2-tone, 5-tone, or
MDC1200
®
“On” and “Off”.
When the Duty function is set to “On”, the display in-
dicates “DUTY ON” briey and the user will always
hear (depending on the sub-audio signaling) all traf-
c on the paging channel. The radio will sound the
paging alert when it receives the programmed 2-tone,
5-tone, or MDC1200
®
.
When the Duty function is set to “Off”, the display
indicates “DUTY OFF” briefly and the user will
NOT hear normal radio traffic on the paging chan-
nel. The radio will sound the paging alert and unmute
only when it receives the programmed 2-tone, 5-tone,
or MDC1200
®
.
Id checK
(
eVx-534 & eVx-539
)
This function allows logged ID of the DTMF Signal-
ing or 5-tone Signaling to be reviewed and relayed
(5-tone Signaling only) to a specic station:
r
Press, (or press and hold), the assigned
PF
key to
display the logged ID of the DTMF Signaling or
5-tone Signaling.