Operation Manual

EVX-530 SEriES OpErating Manual
24
adVanced operatIon
r
Press the
SIDE-1
/
SIDE-2
buttons (or
[
A
]
/
[
B
]
keys) to select the desired squelch level. Available
selections are “SQLLV OP (Open)”, “SQLLV
TH (Threshold)”, “SQLLV NM (Normal)” and
“SQLLV TI (Tight)”.
r
Press the
[
D
]
key to store the new setting. The
display indicates “- SET -” briey, then reverts to
the normal channel indication.
You may cancel the new setting by pressing the
[
C
]
key. In this case, the display indicates “-
CANCEL -” briey.
Beep off
Press, (or press and hold), the assigned
PF
key to
disable the radio beeps temporarily. Press again, (or
press and hold again), the assigned
PF
key to enable
the radio beeps.
In the
EVX-534/-539
, when the Beep Off function is
“on” and “off”, the display indicates briey “BEEP
OFF” and “BEEP ON”.
Note: if the Channel Announcement feature is acti-
vated on the
EVX-534/-539
, the Channel Announce-
ment also disables and enables when the Beep Off
function is “on” and “off”.
af mInImum Volume
(
eVx-534 & eVx-539
)
Press, (or press and hold), the assigned
PF
key, the
display indicates “AFATT ON” briefly, and reduce
the audio output to the (lower) level programmed.
Again press, (or press and hold), the assigned
PF
key,
the display indicates “AFATT OF” briefly, and re-
sume normal audio output level. You may change the
programmed (lower) level by the “User Set (Menu)”
mode. See page 33 for more information.
ch announcement
Press, (or press and hold), the assigned
PF
key to se-
lect the channel change conrmation between “beep”
(In the
EVX-534/-539
, indicates “BEEP” briefly)
and “announcement” (In the
EVX-534/-539
, indi-
cates “ANNOUNCE” briey).
WhIsper
Press, (or press and hold), the assigned
PF
key to
increase the microphone gain; thus you can speak in
a low voice (whisper) temporarily. Press again, (or
press and hold again), the assigned
PF
key to resume
normal microphone gain.
In the
EVX-534/-539
, when the Whisper function is
“on” and “off”, the display indicates “WHISP ON”