Operation Manual

EVX-530 SEriES OpErating Manual
31
talK around
(
ta
)
Press, (or press and hold), the assigned
PF
key to
activate the Talk Around feature when you are op-
erating on duplex channel systems (separate receive
and transmit frequencies, utilizing a “repeater” sta-
tion). The Talk Around feature allows you to bypass
the repeater station and talk directly to a station that
is nearby. This feature has no effect when you are
operating on “simplex” channels, where the receive
and transmit frequencies are already the same. In the
EVX-534/-539
, when the Talk Around feature is ac-
tivated, the “ ” icon will be indicated on the display.
Note that your dealer may have mode provision for
“Talk Around” channels by programming “repeater”
and “Talk Around” frequencies on two adjacent chan-
nels. If so, the key may be used for one of the other
Pre-Programmed Functions.
Note: The Talk Around feature does not activate on
the Simplex Channel.
reset
Press (or press and hold) the assigned
PF
key to reset
the RFC (Ready for Communication) condition.
call 1 to call 3
(
eVx-531
)
call 1 to call 5
(
eVx-534 & eVx-539
)
Press, (or press and hold), the assigned
PF
key to
send a pre-programmed call signal of the 2-Tone,
5-Tone, MDC1200
®
or Digital Call.
code up/doWn
(
eVx-534 & eVx-539
)
Press, (or press and hold), the assigned
PF
key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
code set
(
eVx-534 & eVx-539
)
You can change the desired digit of the 5-Tone en-
code code using this function:
r
Press, (or press and hold), the assigned
PF
key.
r
Enter the desired 5-Tone encode code directly
from the keypad
([
0
]
-
[
9
]
key
)
.
r
Press the
[
D
]
key to store the new setting. The
display indicates “- SET -” briey, then reverts to
the normal channel indication.
You may cancel the new setting by pressing
the
[
C
]
key. In this case, the display indicates
“- CANCEL -” briey.
adVanced operatIon