Operation Manual

EVX-530 SEriES OpErating Manual

WarnIng! Ic rss general requIrement

englIsh

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and max-

imum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to

other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power

(e.i.r.p.) is not more than that necessary for successful communication.

This radio transmitter (identify the device by certification

number, or model number if Category II) has been approved

by Industry Canada to operate with the antenna types listed

at the right with the maximum permissible gain and required

antenna impedance for each antenna type indicated. Antenna

types not included in this list, having a gain greater than the

maximum gain indicated for that type, are strictly prohibited

for use with this device.



When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away from

your mouth and keep the antenna at least 2 inches (5 cm) away from your head and body.



The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-

Talk congurations.

DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than

50% of the time can cause IC RSS General Requirement to be exceeded. To keep the Body Worn congu-

ration with the Vertex Standard CLIP-20 belt-clip, reduce the maximum operating duty cycle still more.

The radio is transmitting when the red LED on the top of the radio is illuminated. You can cause the ra-

dio to transmit by pressing the P-T-T button.



SAR compliance for body-worn use was only demonstrated for the specic belt-clip (CLIP-20). Other

body-worn accessories or congurations may NOT comply with the IC RSS General Requirement and

should be avoided.



When operate the radio with the Vertex Standard CLIP-20 belt-clip, make the transmission time as short

as possible, to keep the Body Worn conguration.

Vhf model uhf model

 ATV-16A:2.15dBi,50-ohm  ATU-16A:2.15dBi,50-ohm

 ATV-16B:2.15dBi,50-ohm  ATU-16B:2.15dBi,50-ohm

 ATV-16C:2.15dBi,50-ohm  ATU-16C:2.15dBi,50-ohm

 ATV-16XL:2.15dBi,50-ohm  ATU-16F:2.15dBi,50-ohm

ATU-16BS:2.15dBi,50-ohm

ATU-16DC:2.15dBi,50-ohm