Operation Manual

EVX-5300/-5400 OpErating Manual
29
r
Press the
[
P4
]
key again to store the new setting into the contact list as the
Private Call. You may cancel the new setting by pressing the
[
P3
]
key.
IV
)
Manual: This category allows you to perform the “CALL ALT”, “RADIO
CK”, “RADIOMON”, “REVIVE” and “STUN” function for the desired Contact
Alias manually by the following operation. Important Note: This function require
the optional
MH-75
A8J
16-Keypad Microphone.
r
Press the
[
P4
]
key, the display indicates “ENTER ID” briey, enter the “ID
number” you wish to operate the function, using the
[
0
]
-
[
9
]
key (for select
the number) and
[
A
]
/
[
B
]
key (for select the digit).
r
Press the
[
P4
]
key again, then press the
[

]
/
[

]
keys (or
[
P1
]
/
[
P2
]
keys) to
select the desired function described above.
r
Press the
[
P4
]
key to perform the function. You may cancel the function by
pressing the
[
P3
]
key.
Note: If the optional
MH-75
A8J
16-Keypad Microphone is used, you may use the
[
A
]
,
[
B
]
,
[
C
]
, and
[
D
]
keys in place of
[
P1
]
,
[
P2
]
,
[
P3
]
, and
[
P4
]
keys.
status sEt
(
This function is only available in the EVX-5400
)
You can change the 5-tone status code using this function:
r
Press, (or press and hold), the assigned
PF
key to change the 5-tone status
code.
r
Select the desired digit to be changing by pressing the
[
P1
]
/
[
P2
]
keys, then
change the number by pressing the
[

]
/
[

]
keys.
r
Press the
[
P4
]
key to store the new number to the 5-tone status code. The dis-
play indicates “- SET -” briey, then reverts to the normal channel indication.
You may cancel the new setting by pressing the
[
P3
]
key. In this case, the dis-
play indicates “-CANCEL-” briey.
Note: If the optional
MH-75
A8J
16-Keypad Microphone is used, you may enter the
5-tone status code directly from the microphone’s numeric
([
0
]
-
[
9
])
key.
status up/doWn
(
These functions are only available in the EVX-5400
)
Press, (or press and hold), the assigned
PF
key to select a 5-tone status code from
the pre-dened status list.
status cHEcK
(
This function is only available in the EVX-5400
)
Press, (or press and hold), the assigned
PF
key to check the 5-tone receive status
code. When you press this key, the display will indicate the “Message” corre-
sponding to the receive status condition per the pre-dened status list.
adVancEd opEratIon