Specifications

46 FT-1802M OPERATING MANUAL
MEMORY BANK LINK SCAN
When the Memory Bank feature is engaged, the scanner sweeps only memory channels in
the current Memory Bank. However, if the Memory Bank Link Scan feature is enabled, you
may sweep the memory channels in several Memory Banks which you have selected.
To enable the Memory Bank Link Scan feature:
1. Set the radio to the Memory mode by pressing the
[
D/MR
(
MW
)]
key, if necessary.
2. Press and hold in the
[
MHz
(
SET
)]
key for one second, then
rotate the DIAL knob to select “8 BNK.LNK.”
3. Press the
[
MHz
(
SET
)]
key momentarily, then rotate the DIAL knob to select the first
Memory Bank (“b1” ~ “b8”) you wish to sweep using
Memory Bank Link Scan.
4. Press the
[
D/MR
(
MW
)]
key momentarily. A “SKIP” icon will blink above the Memory
Bank number, indicating this Memory Bank will now be
swept during Memory Bank Scan.
5. Repeat steps 3 and 4 above, to append the blinking “SKIP”
icon to any other Memory Banks you wish to sweep.
6. Now, press and hold in the
[
MHz
(
SET
)]
key for one second to initiate the Memory Bank
Link Scan.
7. To remove a Memory Bank from the Memory Bank Link Scan, repeat steps 2 - 4 above,
to delete the blinking “SKIP” icon from the Memory Bank number indication.
SCANNING