Specifications

DMU-2000 DATA MANAGEMENT UNIT Page 1
DMU
TRX
KEYBOARD
Supplied Connection Cable
MONITOR
~AC IN
~AC IN Antenna
INSTALLATION AND CONNECTION
1. Make certain that all cables are disconnected from the
transceiver.
2. Referring to Figure 1, remove the three screws from
each side of the transceiver, and three screws from the
top edge of the rear panel. Slide the top cover toward
the rear about 1/2 inch (1 cm), then remove the top
cover.
3. Refer to Figure 2 for the mounting location for the
SCOPE Unit. Locate the 14-pin plug taped on the chas-
sis. Remove the tape and remove the 14-pin plug from
the chassis.
4. Mount the SCOPE Unit using the supplied four screws
(Figure 3).
5. Referring to Figure 4, plug the 14-pin plug which was
removed from the chassis in the previous step into the
J7002 connector on the SCOPE Unit.
6. Locate the Coaxial plugs
(
labeled
and
)
installed
in jacks (J4508 and J4507) on the RX-2 Unit. Unplug
the Coaxial plug
( )
from the RX-2 Unit and plug it
into J7003 on the SCOPE Unit. Unplug the Coaxial
plug
( )
from the RX-2 Unit and plug it into J7001
on the SCOPE Unit (Figure 4).
7. Replace the top cover and its nine screws.
8. Connect the transceiver, Data Management Unit, af-
ter-market Display, and after-market Keyboard (if
used) as shown in Figure 5.
FIGURE 1
FIGURE 2
FIGURE 3
SCOPE Unit Mounting Location
14-pin Plug
FIGURE 4
14-pin Plug
SCOPE Unit
RX-2 Unit
FIGURE 5
Move the Coaxial plug
Move the Coaxial plug
Keep an inch (2.5 cm) of space on
either side of the DMU-2000 to pre-
vent overheating.
FT-2000/FT-2000D