Specifications

DMU-2000 DATA MANAGEMENT UNITPage 34
LOG BOOK FUNCTION
LOG BOOK DATA INPUT
Log data may be entered by the user. Depending on the user (CONFIG) setup for “LOGGING TYPE,” there are two
logging modes: In the “CONTEST” mode, the operator just enters the callsign, signal report, and the REM (“remarks”)
fields, and the Date/Time/Band/Mode are all entered automatically. In the “NORMAL” mode, additional information may
be entered, such as the Country, City, and Name. Up to 500 stations may be stored into a file.
Please enter the log data in accordance with the example in the illustration.
Advice: Before you start logging, we recommend that you perform the CONFIG SETTING MODE procedure within the
User setup (CONFIG) protocol.
1. Referring to the Figure

on page 31, use your key-
board to enter the callsign in the “CALL” field. Then
press the keyboard’s
[
ENTER
]
key.
2. The callsign will be checked against the previous en-
tries to see if it is a duplicate; if so, the “CALLSIGN
REPETITION CHECKLIST” will open, listing this
and any other duplicates. During the QSO, if you wish
to delete the callsign and other information for this
line, just press the keyboard’s
[
ESC
]
key.
3. Enter all desired data in accordance with the example
in the picture. When finished, press the keyboard
[
EN-
TER
]
key.
Note: In order to ensure preservation of log data, be sure
to Save the data frequently. It is always a good idea to
maintain a paper archive copy of log data. Vertex Stan-
dard specifically disclaims responsibility for any liability
arising from the loss of log data.
CALLSIGN REPETITION CHECK LIST
Advice: When entering the Zone via the “ITUZR” field,
pressing the key-board
[
ENTER
]
key will move you to
the CQ Zone (CQZR); from there, use the key-board’s
[

]
key to navigate back to the “ITUZR” field, if desired.
When doing input of the “PREFIX,” “CQZR” (or
“ITUZR”), “ENTITY,” and “QRA” data, please set the
“LOGGING TYPE” to “NORMAL” beforehand. This
will allow you to move from column to column by press-
ing the key-board’s
[
ENTER
]
key. In addition, when (for
example) entering the “PREFIX” and pressing the key-
board’s
[
ENTER
]
key, the “PREFIX SELECT LIST”
will appear, and the “ENTITY” and “CQZR” (or “ITUZR”)
will automatically be entered.