Specifications

FCC ID: K6620275X40

IC ID: 511B-20275X40

FTM-10R Operating Manual

turned off. Now, the DIAL knob becomes dial knob.

2. Rotating the DIAL knob allows tuning in the pre-programmed steps. Clockwise

rotation of the DIAL knob causes the transceiver to be tuned toward a higher

frequency, while counter-clockwise rotation will lower the operating frequency.

3. Press and hold the one of the front panel’s [BANDS]/[BANDT] key for one second

(blink the MHz digits), then rotate the DIAL knob, to change the frequency steps to

1 MHz per step. This feature is extremely useful for making rapid frequency

excursions over the wide tuning range of the FTM-10R.

2) Direct Keypad Frequency Entry (Requires the optional MH68A6J Microphone)

The keypad of the optional MH-68A6J DTMF Microphone may be used for direct entry

of the operating frequency.

To enter a frequency from the MH-68A6J keypad, just press the numbered digits in the

proper sequence. There is no “decimal point” key on the MH-68A6J keypad.

Examples: To enter 146.520 MHz, press [1]  [4]  [6]  [5]  [2]  [0]

To enter 146.5375 MHz, you do not need to press final “5” in the frequency: [1]  [4] 

[6]  [5]  [3]  [7]

3) Scanning

You may scan the VFO frequency by simple operation.

1. Press the [TOPT]/[TOPS] key repetitively, until the “SCAN” notation appears on

the display.

2. Press the [F] key momentarily to initiate upward scanning. The FTM-10R will stop

when it receives a signal strong enough to break through the squelch threshold.

The FTM-10R will then hold on that frequency according to the setting of the

“Resume” mode (Menu Item “F25 RESUME”; see page ??).

3. If you want to change direction of the scan while it is underway, rotate the DIAL

knob one click in the opposite direction (in this case, one click counter-clockwise).

You will see the scanner turn around and change frequency down.

4. If and when the scanner encounters a signal strong enough to open the squelch, the

scanner will halt temporarily; the decimal pint of the frequency display will blink

during this “Pause” condition.

5. The scanner will then resume according to the Scan Resume mode selected in the

previous section.

6. To cancel scanning, press the [F] key momentarily again.

Vertex Standard Co., Ltd.