Specifications

FCC ID: K6620275X40

IC ID: 511B-20275X40

FTM-10R Operating Manual

Automatic Repeater Shift

The ARS (Automatic Repeater Shift) feature in this transceiver allows easy and

convenient repeater operation by automatically activating the repeater shift function

whenever you tune to a standard repeater subband. The ARS function is preset at the

factory to conform to the standards for the country to which it is exported.

The ARS function is enabled at the factory. To disable it:

1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.

2. Rotate the DIAL knob to select Menu Item “F3 ARS.”

3. Press the [X] key to enable selection of this Menu Item.

4. Rotate the DIAL knob to change the display to “OFF.”

5. Press the [SELECT] key momentarily to save the new setting and exit to normal

operation.

To enable the ARS function again, just repeat the above procedure, rotating the DIAL

knob to select “ON” in step 4 above

Separate Transmit Frequency Memories (“Odd Splits”)

All memory channels can store independent receive and transmit frequencies, to

accommodate occasional non-standard offsets with greater frequency resolution than is

available using the “standard” shift feature. See page XX for details.

CTCSS/DCS/EPCS Operation

CTCSS Operation

Many repeater systems require that a very-low-frequency audio tone be superimposed

on your FM carrier in order to activate the repeater. This helps prevent false activation

of the repeater by radar or spurious signals from other transmitters. This tone system,

called “CTCSS” (Continuous Tone Coded Squelch System), is included in your FTM-10R,

and is very easy to activate.

CTCSS setup involves two actions: setting the Tone Mode and then setting of the Tone

Frequency. These actions are set up by using the Menu Item “F37 SQL TYPE” and “F34

SQL.TSQLF.”

1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.

2. Rotate the DIAL knob to select Menu Item “F38 SQL TYPE.”

3. Press the [X] key to enable selection of this Menu Item.

4. Rotate the DIAL knob so that “TONE SQL” appears on the display; this means that

the Tone Squelch system is active, which mutes your FTM-10R’s receiver until it

Vertex Standard Co., Ltd.