Specifications

FCC ID: K6620275X40
IC ID: 511B-20275X40
FTM-10R Operating Manual
3. Press the [X] key to enable selection of this Menu Item.
4. Rotate the DIAL knob so that “DCS” appears on the display; this means that the
DCS Encoder/Decoder is active, which mutes your FTM-10R’s receiver until it
receives a call from another radio sending out a matching DCS tone.
5. When you have made your selection of the DCS mode, press the [X] key
momentarily, then rotate the DIAL knob two clicks counter-clockwise to select
Menu Item “F36 SQL.DCODE.” This Menu selection allows setting of the DCS code
to be used.
6. Press the [X] key to enable adjustment of the DCS code.
7. Rotate the DIAL knob until the display indicates the DS code (three-digits number)
you need to be using.
8. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
Note: Remember that the DCS is an Encode/Decode system, so your receiver will remain
muted until a matching DCS code is received on an incoming transmission. Switch the
DCS off when you’re just tuning around the band!
EPCS (Enhanced Paging & Code Squelch) Operation
The FTM-10R includes an Enhanced CTCSS tone encoder/decoder and a dedicated
microprocessor providing paging and selective calling features. This allows you to place
a call to a specific station (Paging), and to receive calls of your choice directed only to
you (Code Squelch).
The paging and code squelch systems use two pairs of (alternately switched) CTCSS
tones which are stored in the pager memories. Basically, your receiver remains silent
until it receives the CTCSS tone pair that matches those stored in the Receiving Pager
Memory. The squelch then opens so the caller is heard, and the paging ringer
immediately sounds, if activated. When you close the PTT switch to transmit, the
CTCSS tone pair which is stored in the Transmitting Pager Memory will be transmitted
automatically.
On the paged radio, the squelch will close automatically after the incoming page ends.
Storing the CTCSS Tone Pairs for EPCS Operation
1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.
2. Rotate the DIAL knob to select Menu Item “F22 PAGER.”
3. Press the [X] key to enable selection of this Menu Item.
4. Press and hold the [X] key for one second to appear the current Receiving CTCSS
Vertex Standard Co., Ltd.
22