Manualshelf

Specifications

ManualsBrandsVertex Standard ManualsConsumer electronicsFTM-10SR
21222324252627282930
FCC ID: K6620275X40
IC ID: 511B-20275X40
FTM-10R Operating Manual
Tone Pair.
5. Rotate the DIAL knob to set the CTCSS Tone number which corresponds to the first
tone of the Receiving CTCSS Tone Pair.
6. Press the [BANDS] key, then rotate the DIAL knob to set the CTCSS Tone number
which corresponds to the second tone of the Receiving CTCSS Tone Pair.
7. Repeat step 6 for setting the Transmitting CTCSS Tone Pair.
8. If you a mistake, press the [BANDT] key to move back, then re-select the correct
number.
9. When you have made your selection of both Receiving and Transmitting CTCSS
pair, press the [SELECT] key momentarily to save the new setting and exit to
normal operation.
NOTE: The FTM-10R does not recognize the order of the 1st tone and the 2nd tone. In
other words, for example, the FTM-10R considers both CTCSS pairs “10, 35” and “35,
10” to be identical.
Activating the EPCS
1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.
2. Rotate the DIAL knob to select Menu Item “F22 PAGER.”
3. Press the [X] key to enable selection of this Menu Item.
4. Rotate the DIAL knob to change the display to “ON.”
5. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
To disable the EPCS, just repeat the above procedure, rotating the DIAL knob to select
“OFF” in step 4 above.
When the EPCS is activated, the “T” icon will blink during operation.
CTCSS/DCS/EPCS Bell Operation
During CTCSS Decode, DCS, or EPCS operation, you may set up the FTM-10R such
that a ringing “bell” sound alerts you to the fact that a call is coming in. Here is the
procedure for activating the CTCSS/DCS Bell:
1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.
2. Rotate the DIAL knob to select Menu Item “F6 BELL.”
3. Press the [X] key to enable selection of this Menu Item.
4. Rotate the DIAL knob to set the desired number of rings of the Bell. The available
choices are 1, 3, 5, or 8 rings, CONT (continuous ringing), or OFF.
5. Press the [SELECT] key momentarily to save the new setting and exit to normal
Vertex Standard Co., Ltd.
23