Specifications

FCC ID: K6620275X40

IC ID: 511B-20275X40

FTM-10R Operating Manual

The FTM-10R allows you to scan the VFO frequency and memory channel. It will halt

on signals encountered, so you can talk to the station(s) on that frequency, if you like.

Scanning operation is basically the same in above both modes. Before you begin, take a

moment to select the way in which you would like the scanner to resume scanning after

it halts on a signal.

Setting the Scan-Resume Technique

Three scan-resume modes are available on the FTM-10R:

BUSY: In this mode, the scanner will remain halted for as long as there is carrier

present on the channel; after the carrier drops at the end of the other station’s

transmission, scanning will resume.

HOLD: In this mode, the scanner will halt on a signal it encounters. It will not restart

automatically; you must manually re-initiate scanning if you wish to resume.

TIME 3S/5S10: In these modes, the scanner will halt for the selected resume time, after

which scanning will resume (whether or not the other station is still transmitting).

The default scan-stop mode is “BUSY.” To change the scan-resume mode, use the

following procedure:

1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.

2. Rotate the DIAL knob to select Menu Item “F26 RESUME.”

3. Press the [X] key to enable selection of this Menu Item.

4. Rotate the DIAL knob to set the desired scan-resume mode.

5. Press the [SELECT] key momentarily to save the new setting and exit to normal

operation.

VFO Scanning

1. Press the [TOPT]/[TOPS] key repetitively, until the “SCAN” notation appears on

the display.

2. Press the [F] key momentarily to initiate upward scanning.

3. If you want to change direction of the scan while it is underway, rotate the DIAL

knob one click in the opposite direction (in this case, one click counter-clockwise).

You will see the scanner turn around and change frequency down.

4. If and when the scanner encounters a signal strong enough to open the squelch, the

scanner will halt temporarily; the decimal pint of the frequency display will blink

during this “Pause” condition.

5. The scanner will then resume according to the Scan Resume mode selected in the

Vertex Standard Co., Ltd.