Specifications

FCC ID: K6620275X40

IC ID: 511B-20275X40

FTM-10R Operating Manual

previous section.

6. To cancel scanning, press the [F] key momentarily again.

Note: 1) In the factory default, the scanner initiates upward scanning. You may change

the scan start direction to downward scanning by Menu Item “F31 SCN.UP/DN.”

2) In the factory default, the FTM-10R considers the 144 MHz Amateur Band and 430

MHz Amateur Band to be an

independent band

while the scanner is activated. You may

change scanner operation so that the FTM-10R considers the 144 MHz Amateur Band

and 430 MHz Amateur Band to be

one band

while the scanner is activated by Menu

Item “F29 SCN.RANGE.”

3) In the factory default, the VFO frequency will jump to the low band edge of the

current band when the VFO frequency reaches the high band edge. You may change the

scanner operation so that the VFO frequency will change to downward scanning when

the VFO frequency reaches the high band edge by Menu Item “F30 SCN.VTYPE.”

Memory Channel Scanning

Memory Channel Scanning is similarly easy to initiate:

1. Set the FTM-10R to the memory mode by pressing the [X] key, then select the

scanning band by the [BANDT]/[ BANDS] key, if needed (If you need to scan the

all memory channel, set the scanning band to “GRP” band).

2. Press the [TOPT]/[TOPS] key repetitively, until the “SCAN” notation appears on

the display.

3. Press the [F] key momentarily to initiate upward scanning.

4. If you want to change direction of the scan while it is underway, rotate the DIAL

knob one click in the opposite direction (in this case, one click counter-clockwise).

You will see the scanner turn around and change frequency down.

5. If and when the scanner encounters a signal strong enough to open the squelch, the

scanner will halt temporarily; the decimal pint of the frequency display will blink

during this “Pause” condition.

6. The scanner will then resume according to the Scan Resume mode selected in the

previous section.

7. To cancel scanning, press the [F] key momentarily again.

Memory Skip Scanning

When you have some continuously-active channels in memories, you may wish to skip

them for scanning, but still have them available for manual selection.

To mask a memory to be skipped (only) during scanning, use the following procedure:

Vertex Standard Co., Ltd.