Manualshelf

Specifications

ManualsBrandsVertex Standard ManualsConsumer electronicsFTM-10SR
31323334353637383940
FCC ID: K6620275X40
IC ID: 511B-20275X40
FTM-10R Operating Manual
1. Set the FTM-10R to the Memory Recall mode by pressing the [X] key, if necessary,
“M” notation appears on the right side of the display.
2. Rotate the DIAL knob to select the Memory Channel to be skipped during scanning.
3. Press and hold the [X] key to enter the Memory Channel Customization mode.
4. Rotate the DIAL knob to select Menu Item “M6 SKIPONLY.”
5. Press the [X] key momentarily, then rotate the DIAL knob so as to select “SKIP.”
The current Memory Channel will now be ignored during scanning. The “ONLY”
selection is used for “Preferential Memory Scan,” described in the next section.
6. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
To re-institute a channel into the scanning loop, select “OFF” in step 5 above, after first
recalling the currently-blocked channel (the “skipped” channel is accessible via manual
channel selection methods using the DIAL knob in the Memory mode, whether or not it
is locked out of the scanning loop).
Preferential Memory Scan
The FTM-10R also allows you to set up a “Preferential Scan List” of channels which you
can “flag” within the memory system. When you initiate the Preferential Memory Scan,
only “flagged” channels will be scanned.
Here is the procedure for setting up the Preferential Scan List:
1. Set the FTM-10R to the Memory Recall mode by pressing the [X] key, if necessary,
“M” notation appears on the right side of the display.
2. Rotate the DIAL knob to select the Memory Channel to be skipped during scanning.
3. Press and hold the [X] key to enter the Memory Channel Customization mode.
4. Rotate the DIAL knob to select Menu Item “M6 SKIPONLY.”
5. Press the [X] key momentarily, then rotate the DIAL knob so as to select “ONLY.”
The current Memory Channel is listed on the Preferential Scan List.
6. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
To initiate Preferential Memory Scan
1. Set the FTM-10R to the Memory Recall mode by pressing the [X] key, if necessary,
“M” notation appears on the right side of the display.
2. Press and hold the [X] key to enter the Memory Channel Customization mode.
3. Rotate the DIAL knob to select Menu Item “M5 SCN.TYPE.”
4. Press the [X] key momentarily, then rotate the DIAL knob to “ONLY MEM.”
Vertex Standard Co., Ltd.
32