Manualshelf

Specifications

ManualsBrandsVertex Standard ManualsConsumer electronicsFTM-10SR
41424344454647484950
FCC ID: K6620275X40
IC ID: 511B-20275X40
FTM-10R Operating Manual
operation.
Volume Setting Alert feature
The FTM-10R provide the Volume Setting Alert feature which is .
1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.
2. Rotate the DIAL knob to select Menu Item “F46 VOL.PRESET.”
3. Press the [X] key to enable selection of this Menu item.
4. Rotate the DIAL knob to select the desired effect level.
ON-SET: Activates the Volume Setting Alert feature. A lamp of the left of the DIAL
knob blinks orange when volume level is set to the ±3 steps of the preset level.
ON-HI: Activates the Volume Setting Alert feature. A lamp of the left of the DIAL
knob blinks orange when volume level is set to the preset level plus 3 steps above.
ON-LOW: Activates the Volume Setting Alert feature. A lamp of the left of the DIAL
knob blinks orange when volume level is set to the preset level minus 3 steps.
OFF: Disable the Volume Setting Alert feature.
5. Press and hold the [X] key for one second, then rotate the DIAL knob to select the
desired preset level.
6. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
Reset Procedure
In some instances of erratic or unpredictable operation, the cause may be corruption of
data in the microprocessor (due to static electricity, etc.). If this happens, resetting of
the microprocessor may restore normal operation. Note that all memories will be erased
if you do a complete microprocessor reset, as described below.
1. Turn the radio off.
2. Press and hold in the [SELECT] key while turning the radio on.
3. Rotate the DIAL knob to select one of the selections from the reset menu:
SF1 ALL COPY: Transfer the all memories and other settings from a transceiver to
another FTM-10R. This is not reset operation.
SF2 MSG COPY: Transfer the all message from a transceiver to another FTM-10R.
This is not reset operation.
SF3 MSG CLR: Resets the message to factory defaults.
SF4 SYS CLR: Resets the Set (Menu) mode settings to their factory defaults.
Vertex Standard Co., Ltd.
44