Specifications

FCC ID: K6620275X40

IC ID: 511B-20275X40

FTM-10R Operating Manual

How to use the supplied Angle Sub Panel

FTM-10R can tilt the front panel by using supplied Angle Sub Panel.

 Remove the four screws affixing the Front Panel, then remove the Front Panel from

the transceiver’s body.

 Disconnect the 8-pin modular plug from the transceiver’s body.

 Remove a screw affixing the Straight Sub Panel, then remove the Straight Sub

Panel from the Front Panel.

 Affix the supplied Angle Sub Panel to the Front Panel, using the previously

removed screw. You may set up to “look-up” or “look-down” direction by a direction

to install.

 Connect the 8-pin modular plug from the transceiver’s body.

 Affix the Front Panel (with Angle Sub Panel) to the transceiver’s body, using the

previously removed four screws.

Mobile Power Connections

To minimize voltage drop and avoid blowing the vehicle’s fuses, connect the supplied DC

power cable directly to the battery terminals. Do not attempt to defeat or bypass the DC

cable’s fuse - it is there to protect you, your transceiver, and your vehicle’s electrical

system.

Warning!

Never apply AC power to the power cable of the FTM-10R, nor DC voltage greater than

15.8 Volts. When replacing the fuse, only use a 15-A fuse. Failure to observe these safety

precautions will void the Limited Warranty on this product.

 Before connecting the transceiver, check the voltage at the battery terminals while

revving the engine. If the voltage exceeds 15 Volts, adjust the vehicle’s voltage

regulator before proceeding with installation.

 Connect the RED power cable lead to the POSITIVE (+) battery terminal, and the

BLACK power cable lead to the NEGATIVE (–) terminal. If you need to extend the

power cable, use #12 AWG or larger insulated, stranded copper wire. Solder the

splice connections carefully, and wrap the connections thoroughly with insulating

electrical tape.

 Before connecting the cable to the transceiver, verify the voltage and polarity of the

voltage at the transceiver end of the DC cable using a DC voltmeter. Now connect

the transceiver to the DC cable.

Mobile Speakers

Vertex Standard Co., Ltd.