Specifications

103FTM-10SR OPERATING MANUAL
INSTALLATION OF OPTIONAL ACCESSORIES
BU-1 Bluetooth
®
ADAPTER UNIT
Please be sure to follow these safety precautions:
P Turn the transceiver power off, and disconnect all cables from the transceiver.
P Touch a metal place to discharge any static electricity from your body.
Installing the “BU-1” in the Front Panel
1. Remove the four screws securing the
Rear Case of the Front Panel and re-
move the Rear Case from the Front
Panel.
Note: When you remove the rear case,
you will find a small thin green wire
near the flat ribbon cable. Be careful
not to cut or damage this wire.
connector
BU-1
2. Carefully align the connector on the
BU-1 with the connector on the Printed
Circuit Board, and gently press the BU-
1 into place.
3. Replace the Rear Case to the Front
Panel using the previously removed
four screws.
Installing the “BU-1” in the Transceiver Body
1. Remove the four screws securing the
plastic cover and lift the plastic cover
from the Transceiver Body.
connector
2. Carefully align the connector on the
BU-1 with the connector on the Printed
Circuit Board, and gently press the BU-
1 into place.
3. Replace the plastic cover to the Trans-
ceiver Body using the previously re-
moved four screws.
P Be certain the waterproof packing
on the back of the plastic cover is
correctly installed, and the cover
adheres and seals properly.
P Tighten the four screws evenly to
maintain the waterproof perfor-
mance.