User's Manual

FT-950
Operating Manual
Vertex Standard Co., Ltd.
118
ACS: Iambic keyer with ACS (Automatic Character Spacing) enabled.
040 A1A R-REV
Function: Selects the keyer paddle’s wiring configuration for the KEY jack on the rear
panel.
Available Values: nor/rEV
Default Setting: nor
nor: Tip = Dot, Ring = Dash, Shaft = Ground
rEV: Tip = Dash, Ring = Dot, Shaft = Ground
041 A1A CW AUTO
Function: Enables/disables CW keying while operating on SSB.
Available Values: OFF/50/On
Default Setting: OFF
OFF: Disables CW keying while operating on SSB.
50: Enables CW keying only while operating SSB on 50 MHz (but not HF).
On: Enables CW keying while operating on SSB (all TX bands).
Note: This feature allows you to move someone from SSB to CW without having to
change modes on the front panel.
042 A1A BFO
Function: Sets the CW carrier oscillator injection side for the CW mode.
Available Values: USb/LSb/Auto
Default Setting: USb
USb: Injects the CW carrier oscillator on the USB side.
LSb: Injects the CW carrier oscillator on the LSB side.
Auto: Injects the CW carrier oscillator on the LSB side while operating on the 7
MHz band and below, and the USB side while operating on the 10 MHz band
and up.
043 A1A BK-IN
Function: Sets the CW “break-in” mode.
Available Values: SEni/FuLL
Default Setting: SEni
SEni (SEMI): The transceiver will operate in the semi break-in mode. The delay
(receiver recovery) time is set via the Menu item “044 A1A DELAY”.