User's Manual

FT-950
Operating Manual
Vertex Standard Co., Ltd.
119
FuLL: The transceiver will operate in the full break-in (QSK) mode.
044 A1A DELAY
Function: Adjusts the Keying Delay (receiver recovery) time on the CW mode.
Available Values: 30 ~ 3000 msec
Default Setting: 300 msec
045 A1A PITCH
Function: Adjusts your preferred CW tone pitch.
Available Values: 300 ~ 1050 Hz
Default Setting: 700 Hz
046 A1A WEIGHT
Function: Sets the Dot:Dash ratio for the built-in electronic keyer.
Available Values: (1:) 2.5 ~ 4.5
Default Setting: 3.0
047 A1A FRQDISP
Function: Selects the frequency Display Format for the CW mode.
Available Values: dir/OFSt
Default Setting: OFSt
dir (Direct Frequency): Displays the receiver carrier frequency, without any offset
added. When changing modes between SSB and CW, the
frequency display remains constant.
OFSt (Pitch Offset): This frequency display reflects the added BFO offset.
048 A1A PC KYNG
Function: Enables/disables CW keying from the “DATA IN” terminal on the rear panel’s
RTTY/PKT jack while operating on the CW mode.
Available Values: EnA (Enable)/diS (Disable)
Default Setting: diS (Disable)
049 A1A QSKTIME
Function: Selects the time delay between when the PTT is keyed and the carrier is
transmitted during QSK operation when using the internal keyer.
Available Values: 15/20/25/30 msec