User's Manual

FT-950

Operating Manual

Vertex Standard Co., Ltd.

pseudo-straight-key operation.

Note: You cannot use a 2-contact plug in this jack (to do so produces a constant “key

down” condition).

18. [MONI] Knob

This knob adjusts the audio level of the transmit RF monitor during transmission

(relative to the [AF GAIN] knob), when activated by the [MONI] button.

19. [SQL] Knob

This knob sets the signal level threshold which at the receiver audio is muted, in all

modes. It is very useful during local rag-chews, to eliminate noise between incoming

transmissions. This control is normally kept fully counter-clockwise (off), except when

scanning and during FM operation.

20. [SHIFT] Switch

Pressing this button allows you to adjust the IF DSP bandwidth using the [SELECT]

knob. While activated, the LED inside this button glows orange.

21. [WIDTH] Switch

Pressing this button allows you to adjust the overall bandwidth of the IF DSP filter

using the [SELECT] knob. While activated, the LED inside this button glows orange.

22. [CONT] Switch

Pressing this button allows you to select the DSP Contour filter response using the

[SELECT] knob. While activated, the LED inside this button glows orange.

23. [NOTCH] Switch

Pressing this button allows you to adjust the center frequency of the IF Notch filter

using the [SELECT] knob. While activated, the LED inside this button glows orange.

24. [µ-TUNE] Switch

Pressing this button allows you to adjust the center frequency of the µ-Tuning filter

passband using the [SELECT] knob, when the optional RF µTuning Kit is connected.

While activated, the LED inside this button glows orange.

25. [CLEAR] Switch