User's Manual

FT-950
Operating Manual
Vertex Standard Co., Ltd.
20
Pressing this button to reset the status of the functions which is selected from the five
buttons at the left of this button to factory default.
26. [SELECT] Knob
This knob is used to adjust the status of the functions depending on the five buttons
located above this knob.
FUNCTION Switch EFFECT
SHIFT Rotate this knob to vary the passband of the IF DSP filter by 20
Hz steps. The total adjustment range is ±1 kHz.
The position of the passband can be observed on the display.
WIDTH Rotate this knob to set the overall bandwidth of the DSP IF
filter.
Counter-clockwise rotation reduces the bandwidth, while
clockwise rotation increases the bandwidth.
The current bandwidth can be observed on the display.
CONT Pressing this knob to turn the CONTOUR filter on and off.
Rotate this knob to select the CONTOUR filter response.
The peak position of the CONTOUR filter can be observed on
the display.
NOTCH Pressing this knob to turn the IF NOTCH filter on and off.
Rotate this knob to adjust the center frequency of the IF
NOTCH filter.
The null position of the IF NOTCH filter can be observed on the
display.
µ-TUNE Pressing this knob to turn the optional RF µTuning Kit on and
off.
Rotate this knob to adjust the center frequency of the µ-Tuning
filter.
The peak position of the µ-Tuning filter can be observed on the
Tuning Offset Indicator field of the display.
This knob also uses to select the Menu item when the Menu mode is engaged.
Press and hold this knob for two seconds to activate the optional Voice Memory feature
for the SSB/AM/FM modes, or the Contest Keyer for the CW mode. See page ?? (Voice
Memory feature) or page ?? (Contest Keyer) for details.
27. [(VFO-A) RX] Indicator/Switch
This button, when pressed, the transceiver receives the VFO-A frequency. The LED
inside this button will glow green when the transceiver receives the VFO-A frequency.
When the transceiver receives the VFO-A frequency, pressing this button momentarily
will mute the receiver, and the indicator will blink. Pressing the button once more will
restore receiver operation, and the indicator will glow green steadily.
28. QMB (Quick Memory Bank) Switches