User's Manual

FT-950

Operating Manual

Vertex Standard Co., Ltd.

56. [CLEAR] Switch

Pressing this button clears out any frequency offset you have programmed into the

Clarifier register (thereby setting the offset to “Zero”).

57. [(VFO-B)RX] Indicator/Switch

This is the button that switches the receiving frequency to the VFO-B, the green LED

imbedded within the button will light up. Pressing this button again will return the

receiving frequency to the VFO-A, and the imbedded green LED will turn off.

58. [(VFO-B)TX] Indicator/Switch

This is the button that turns the VFO-B transmitter “On” and “Off”. When this button

is pressed to transfer transmitter control to the VFO-B frequency and mode, the red

LED imbedded within the button will light up. Pressing this button again will transfer

frequency/mode control back to the VFO-A side, and the red LED imbedded within this

button will turn off.

59. [BAND] Switch

Pressing this button allows you to select the operating band (Amateur bands) using the

[CLAR/VFO-B] knob.

60. [GRP] Switch

Pressing this button allows you to select the memory group using the [CLAR/VFO-B]

knob.

61. [MHz] Switch

Pressing this button allows you to tune the VFO frequency down or up in 1 MHz

increments, using the [CLAR/VFO-B] knob.

62. [MCH] Switch

Pressing this button allows you to select the memory channel using the [CLAR/VFO-B]

knob.

63. [CLAR/VFO-B] Knob

This knob usually tunes the Clarifier offset frequency up to ±9.99 kHz, otherwise, this

knob is used to adjust the status of the functions depending on the five buttons located

around this knob.