User's Manual

FT-950
Operating Manual
Vertex Standard Co., Ltd.
38
The Tuning Offset Indicator provides a graphical representation of the Clarifier offset.
On CW, the Tuning Offset Indicator is used for CW Center Tuning, instead of Clarifier
Offset, as the transceiver is configured at the factory. If you wish to change this, so that
the Clarifier Offset is also displayed on CW, use the following procedure:
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the [SELECT] knob to select Menu item “006 DISP BAR SEL”.
Advice: Press the [SELECT] knob to toggle the Menu item display between “006
DISP” and “BAR SEL”.
3. Rotate the [CLAR/VFO-B] knob to select “CLAr (Clarifier)” (replacing the default
“C-tn (CW TUNING)” selection).
4. Press and hold in the [MENU] button for two seconds to save the new setting and
exit to normal operation.
LOCK
You may lock the setting of the Main Tuning Dial knob (for VFO-A frequency tuning)
and the [CLA/VFO-B] knob (for VFO-B frequency tuning), to prevent accidental.
To lock out the Main Tuning Dial knob and the [CLA/VFO-B] knob, just press the
[LOCK] button that is located to the right of the Main Tuning Dial knob. To unlock the
Dial setting, and restore normal tuning, just press the [LOCK] button once more.
DIMMER
The illumination level of the display may be adjusted via the Menu item “005 DISP
DIM VFD”, if you desired.
To adjust the illumination level:
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the [SELECT] knob to select Menu item “005 DISP DIM VFD”.
Advice: Press the [SELECT] knob to toggle the Menu item display between “005
DISP” and “DIM VFD”.
3. Rotate the [CLAR/VFO-B] knob to select desired illumination level.
4. Press and hold in the [MENU] button for two seconds to save the new setting and
exit to normal operation.
Convenience Features