User's Manual
FT-950
Operating Manual
Vertex Standard Co., Ltd.
40
the band-selection loop (when using the [CLAR/VFO-B] knob for band selection).
The available choices are 1.8/3.5/5/7/10/14/18/21/24/28/50/GE (General Band).
4. Press the [ENT] button to set the omission command to ON. The “E” (Enable)
notation at the right of the band notation will change to “d” (disable).
5. Repeat steps 3 and 4 to select/deselect as many bands as you like.
Note: The “ON” command sets the selected band to be
skipped
, while the “OFF”
command sets the selected band to be
included
in the band-selection list. Return
the “d” notation to “E” to restore operation on a previously-deleted band.
6. Press and hold in the [MENU] button for two seconds to lock in the new
configuration and exit to normal operation.
Advice: The “My Band” feature affects both the VFO-A and VFO-B.
“My Band” Operation
1. Press the [BAND] button at the left of the [CLAR/VFO-B] knob; the imbedded LED
will glow orange.
2. Rotate the [CLAR/VFO-B] knob to choose the Amateur band on which you wish to
operate. Only those Amateur bands that have
not
been skipped will appear as you
scroll through the bands.
To disable the “My Band” Operation, press the [BAND] button again; the imbedded
orange LED goes out.
Advice: The “My Band” feature affects both the VFO-A and VFO-B.
Band Stack Operation
The FT-950 utilizes a triple band-stack VFO selection technique, that permits you to
store up to three favorite frequencies and modes onto each band’s VFO register. For
example, you may store one frequency each on 14 MHz CW, RTTY, and USB, then
recall these VFOs by successive, momentary presses of the [14] MHz band button. Each
Amateur band key may similarly have up to three frequency/mode settings applied.
Both the VFO-A and VFO-B systems have their own, independent, band stacks.
A typical setup, for the 14 MHz band, might be arranged like this:
1. Program 14.025 MHz，CW Mode, then press the [14] MHz band button;
2. Program 14.080 MHz，RTTY Mode, then press the [14] MHz band button;
3. Program 14.195 MHz, SSB Mode, then press the [14] MHz band button.