User's Manual

FT-950
Operating Manual
Vertex Standard Co., Ltd.
88
termination of the message.
8. Press and hold in the [SELECT] button for two seconds to exit, once all characters
(including “}”) have been programmed.
Advice: Momentarily pressing the [SELECT] button is canceling the programming.
Deleting Previously-stored Characters
Use the Main Tuning Dial knob to select the last correct letter in the message. Now
rotate the [CLAR/VFO-B] knob to select the “}” character; everything after the “}”
character will be deleted.
Checking the CW Memory Contents
1. Be sure that Break-in is still turned “Off” by the [BK-IN] button.
2. Press the [MONI] button to enable CW monitor. A “MONI” icon will appear in the
display.
3. Press and hold the [SELECT] knob for two seconds to activate the Contest Memory
Keyer. Indicates one of following indication in Multi-Display Window on the
display; “REC1”, “REC2”, “REC3”, “REC4”, “REC5”, “PLY1”, “PLY2”, “PLY3”,
“PLY4”, and “PLY5”.
4. Rotate the [SELECT] knob to select the CW Memory Register (“PLY1” through
“PLY5”) whichever one you just recorded in.
5. Press the [SELECT] knob. A “PLAY” icon will appear in the display, and you will
hear the results in the sidetone, but no RF energy will be transmitted.
Note: Adjust the monitor level using the [MONI] knob.
On-The-Air CW Message Playback
1. Press the [BK-IN] button to enable transmission. Either Full- or Semi-break-in
will be engaged, depending on the setting of Menu item “043 A1A BK-IN.”
2. Press the [MONI] button to enable CW monitor. A “MONI” icon will appear in the
display.
3. Press and hold the [SELECT] knob for two seconds to activate the Contest Memory
Keyer. Indicates one of following indication in Multi-Display Window on the
display; “rEC1”, “rEC2”, “rEC3”, “rEC4”, “rEC5”, “PLY1”, “PLY2”, “PLY3”, “PLY4”,
and “PLY5”.
4. Rotate the [SELECT] knob to select the CW Memory Register (“PLY1” through
“PLY5”) which you wish to transmit.
5. Press the [SELECT] knob. A “PLAY” icon will appear in the display, and transmit