User's Manual

FT-950
Operating Manual
Vertex Standard Co., Ltd.
96
Quick Point:
The FT-950’s memory channels store the following data (not just the operating
frequency):
 VFO-A Frequency
 VFO-A Mode
 Clarifier status and its Offset Frequency
 ANT status
 IPO status
 Roofing filter status and its Bandwidth
 Attenuator status
 Noise Blanker status
 IF SHIFT and WIDTH status
 CONTOUR status and its Peak Frequency
 DSP Noise Reduction (DNR) status and its Reduction algorithm selection.
 DSP Notch filter (NOTCH) status
 NAR bandwidth status
 DSP Auto Notch filter (DNF) status
 Repeater Shift Direction and Shift Frequency
 CTCSS status and Tone Frequency
QMB (Quick Memory Bank)
The Quick Memory Bank consists of five memories (labeled “C-1” through “C-5.”)
independent from the regular and PMS memories. These can quickly store operating
parameters for later recall.
QMB Channel Storage
1. Tune to the desired frequency on the VFO-A.
2. Press the blue [QMB(STO)] button. The “beep” will confirm that the VFO-A
contents have been written to the currently-available QMB memory.
If you repeatedly press the [QMB(STO)] button, the QMB memories will be written in
the following order: C-2
 C-3  C-4  C-5  C-1.
Once all five QMB memories have data on them, previous data (starting with channel
C-1) will be over-written on a first-in, first-out basis.