Operating instructions

Page 10 VX-1700 OPERATING MANUAL

BASE STATION INSTALLATION

DC Power Connections

For base station installations, Yaesu recommends the use

of the Model FP-1030A AC Power Supply. The FP-

1030A provides a regulated 13.8 V DC supply at up to 25

Ampere.

Other models of DC power supplies may be used with the

VX-1700, but the 13.8 V DC input voltage, 25 Ampere

current capability, and DC cable polarity guidelines de-

scribed previously must be strictly followed.

 If you are connecting the FP-1030A with the VX-1700

for the first time, before connecting power check the

label in the rear of the FP-1030A which indicates the

AC mains voltage for which the supply is currently

set.

AUTION! Permanent damage can result if improper sup-

ply voltage is applied to this transceiver. Your warranty

does not cover damage caused by application of AC, re-

versed polarity DC, or DC outside of the specified range

of 13.8 V ±15%. If using a power supply other than the

FP-1030A, ensure that the DC supply connector to the

transceiver matches the VX-1700 wiring configuration.

Other manufacturers may utilize power supplies with a

physically matched connector that is wired differently; this

will cause serious damage to the VX-1700 transceiver!

Supplied DC Cable

005510 2015 3020 40

CONT IN UOUS CURREN T 25A

OVERLOAD

POWER

OFF

FP-1030A

VX-1700

RED BLACK

FUSE: 25A

INSTALLATION