Service manual

15VX-4500/-4600 Series UHF FM Transceiver Service Manual
Alignment
5. TX Power
This parameter is to align the “Power High”, “Power Low3”, “Power Low2” or “Power Low1” for the selected channel.
1. Press the “TX Pwr(H / L3 / L2 / L1)” button to start the
alignment. The TX Power Alignment window will appear.
2. Click the left mouse button on the slide bar or press the Up
/ Down arrow key, to select the desired channel.
3. Click the “PTT” button or press the “SPACE” bar at the
desired channel, then the radio starts to transmit on the se-
lected channel.
4. Set the value to get desired output power on the Power Meter
by dragging the slide bar, clicking the up-down button, press-
ing the left or right arrow key, or entering the value in the
entry box on the selected channel.
5. After getting the desired output power click the “PTT” but-
ton or press the “SPACE” bar to stop transmitting.
6. Click the “OK” button to finish the TX Power alignment
and save the data.
ADJ Type
Basic: “Low-edge / band center / high-edge“ and se-
lect the channel for alignment (Default).
Single: Alignment value changes only on the selected
channel.
All Freq: Alignment value changes on all channels.
«