Specifications

VX-7R OPERATING MANUAL62
AUTOMATIC LAMP ILLUMINATION ON SCAN STOP
The VX-7R will automatically illuminate the LCD Lamp whenever the scanner stops on a
signal; this allows you to see the frequency of the incoming signal better at night. Note that
this will, of course, increase the battery consumption, so be sure to switch it off during the
day (the default condition for this feature is “ON”).
The procedure for disabling the Scan Lamp is:
1. Press the key, then press the key to enter the Set mode.
2. Rotate the DIAL to select the Menu Item labeled (Scan
Modes #4: SCAN LAMP).
3. Press the or key to set this Menu Item to OFF.
4. When you have made your selection, press the PTT to
save the new setting and exit to normal operation.
BAND EDGE BEEPER
The VX-7R will automatically “beep” when a band edge is encountered during scanning
(either in standard VFO scanning or during PMS operation). You may enable this feater
(band edge beeper) when the frequency reaches the band edge while selecting the VFO
frequency by the DIAL.
The procedure for disabling the Band-Edge Beeper is:
1. Press the key, then press the key to enter the Set mode.
2. Rotate the DIAL to select the Menu Item labeled (Scan
Modes #2: EDGE BEEP).
3. Press the or key to set this Menu Item to ON.
4. When you have made your selection, press the PTT to
save the new setting and exit to normal operation.
SCANNING