Specifications

VX-7R OPERATING MANUAL70
Selecting the Wave-Form Display
1. Press the key, then press the key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (Mea-
surements #2: WAVE MONITOR).
3. Press the or key to select the desired wave form
(RX SIGNAL, TX MODULATION, or All).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Selecting the Units of Temperature Display
1. Press the key, then press the key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (Mea-
surements #3: TEMP UNIT).
3. Press the or key to select the preferred unit (°C
or °F).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Selecting the Unit of Atmospheric Pressure Meter (Barometer)
1. Press the key, then press the key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (Mea-
surements #4: BARO UNIT).
3. Press the or key to select the preferred unit (hpa/
mbar/mmHg/inch).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Correcting the Atmospheric Pressure Meter (Barometer Offset)
1. Press the key, then press the key to enter the Set Mode.
2. Rotate the DIAL to select the Menu Item labeled (Measurements #5: BARO OFF-
SET).
3. Press the key to enable setting of this Menu Item.
4. Press the key to indicate the barometer data in “hpa”
units.
5. Press the or key to adjust the VX-7R display to the calibrated barometer
value in the “hpa” units.
6. Press the key to save the new setting.
7. Press the PTT key momentarily to exit to normal operation.
SENSOR MODE
SENSOR MODE OPTIONS