Specifications

VX-3R OPERATING MANUAL 19
ADJUSTING THE KEYPAD BEEPER VOLUME LEVEL
A keypad beeper provides useful audible feed back whenever a keypad is pressed. The
keypad beeper level changes according to the receiver audio volume level setting. How-
ever, you may adjust the volume balance between the receiving audio and keypad beeper
via Set Mode Item 13:
BP LVLBP LVL
BP LVLBP LVL
BP LVL.
1. Press and hold in the
[
TXPO
]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 13:
BP LVLBP LVL
BP LVLBP LVL
BP LVL.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the
[
TXPO
]
key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to select the desired level.
5. When you have made your selection, press the PTT switch to
save the new setting and return to normal operation.
Additionally, if you want to turn the beep off:
1. Press and hold in the
[
TXPO
]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 14:
BP SELBP SEL
BP SELBP SEL
BP SEL.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the
[
TXPO
]
key momentarily to enable adjustment of this
Item.
4. Rotate the DIAL knob to change the setting to “
OFFOFF
OFFOFF
OFF”.
5. Press the PTT switch to save the new setting and return to nor-
mal operation.
6. If you wish to re-enable the Beeper, just repeat the above procedure, rotating the DIAL
knob to select “
KEYKEY
KEYKEY
KEY” or “
KY+SCNKY+SCN
KY+SCNKY+SCN
KY+SCN” in step “4” above.
KEYKEY
KEYKEY
KEY: The beeper sounds when you press any key.
KY+SCNKY+SCN
KY+SCNKY+SCN
KY+SCN: The beeper sounds when you press a key or when the scanner stops.
ADVANCED OPERATION