Specifications

VX-3R OPERATING MANUAL 39
CTCSS/DCS/EPCS OPERATION
13. Press and hold the
[
HM/RV
]
key for one second to delete all data after the current
position that may have previously been stored in the User Beep.
14. When you have programmed User Beep, press the
[
TXPO
]
key momentarily to con-
firm the User Beep.
You may check your work by monitoring the programmed User Beep. To do
this, repeat steps 1 - 4 above, then press the [F/W] key.
SPLIT TONE OPERATION
The VX-3R can be operated in a Split Tone configuration via the Set mode.
1. Press and hold in the
[
TXPO
]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 81:
SQSPLTSQSPLT
SQSPLTSQSPLT
SQSPLT.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the
[
TXPO
]
key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select “
ONON
ONON
ON” (to enable the Split Tone
feature).
5. Press the PTT switch momentarily to save the new setting and exit to normal opera-
tion.
When the Split Tone feature is activated, you can see the following additional parameters
after the “
MESSAGEMESSAGE
MESSAGEMESSAGE
MESSAGE” parameter while selecting the Set Mode Item 79:
SQ TYPSQ TYP
SQ TYPSQ TYP
SQ TYP:
D CODED CODE
D CODED CODE
D CODE: DCS Encode only
(the “ ” icon will blink during operation)
T DCST DCS
T DCST DCS
T DCS: Encodes a CTCSS Tone and Decodes a DCS code
(the “ ” icon will blink and the “ ” icon will appear during operation)
D TONED TONE
D TONED TONE
D TONE: Encodes a DCS code and Decodes a CTCSS Tone
(the “ ” icon will appear and the “ ” icon will blink during operation)
Select the desired operating mode, from the selections shown above, within Set Mode Item
79:
SQ TYPSQ TYP
SQ TYPSQ TYP
SQ TYP.
CTCSS/DCS/EPCS BELL OPERATION